Handy Crimp Instructions

STEP 1
Make sure you have the proper equipment and all parts required. Use a sharp knife to strip vinyl cover (if required).

STEP 2
If you are using vinyl coated cable it will be necessary to strip back the coating.

STEP 3
Insert stripped cable into Handy Crimp fitting and crimp 3 times
Install 3 crimps 1/8″ from end of fitting and 1/8″ apart, rotate 90 degrees for each crimp to ensure straightness of fitting. 

STEP 4
Attach the crimped on end fitting to connection point. Run cable to other connection point. Ensure hardware is adjusted to 2/3rds open position.

STEP 5
Attach un-crimped Handy Crimp fitting to other connection point and pull cable tightly along side. Measure for cut.

STEP 6
Repeat steps #2 and #3 for un-crimped end fitting.

STEP 7
All crimps must be inspected utilizing a Micrometer or Caliper to the following specifications:

• 1/8″ Wire – 0.185

• 3/16″ Wire – 0.265